RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Dieselman1220
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Jets
02-06-2020, 02:11 PM
Replies: 538
Views: 112,965
Posted By Dieselman1220

No I did NOT reverse polarity on the battery...

No I did NOT reverse polarity on the battery input.
I did it on the gear connector to the motor, after further reading though that is irrelevant as it it would only change the direction the gear...
Forum: RC Jets
02-06-2020, 09:27 AM
Replies: 538
Views: 112,965
Posted By Dieselman1220

Hi Tom, thanks for your willingness to help. ...

Hi Tom, thanks for your willingness to help.
UPDATE..one main gear works just fine??
I can access all screens on the controller just fine, when I push retract or extend on the screen it does not...
Forum: RC Jets
02-06-2020, 06:59 AM
Replies: 538
Views: 112,965
Posted By Dieselman1220

Ok pulling my hair out now. I installed...

Ok pulling my hair out now.
I installed everything into the jet and now the gear are not working.
I reinstalled the stock JP controller and everything works fine, so it cannot be a retract motor...
Forum: RC Jets
02-06-2020, 06:51 AM
Replies: 538
Views: 112,965
Posted By Dieselman1220

I had the 2 pin connector from the gear to the...

I had the 2 pin connector from the gear to the controller reversed, however I guess it didn't solve my issue Ill make a separate post.
Forum: RC Jets
02-05-2020, 03:00 PM
Replies: 538
Views: 112,965
Posted By Dieselman1220

I take no offense to double checking the most...

I take no offense to double checking the most basic things.
Such as the case here, I had the polarity reversed on the connector plugging into the LG15.
Thank you everyone for the suggestions.
Forum: RC Jets
02-05-2020, 10:36 AM
Replies: 538
Views: 112,965
Posted By Dieselman1220

My apologies yes, I meant to say ground and...

My apologies yes, I meant to say ground and positive wire for the gear.
yes my center pin is blank my ground is at the bottom of the controller and my positive wire is on the highest pin position.
Forum: RC Jets
02-05-2020, 09:28 AM
Replies: 538
Views: 112,965
Posted By Dieselman1220

Ive been reading this very informative thread and...

Ive been reading this very informative thread and purchased an LG15 for my Ultra Flash Evo.
I hooked the LG15 to the nose gear and set up RC per the LG15 instructions however the gear will not...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.